Eldes EKB3 Instalační manuál stáhnout pdf (Strana 10)

4.3.3 Zones commands

ATZ Mode

WhenATZmode(zoneduplication)isenabled,thezonenumberisincreasedto12.Byde-

fault,ATZmodeisdisabled.

Enter code 28 and function:

Disabled–[280#]

Enabled-[281#]

EKB3

Arm-Disarm

By Zone

Zone Mode No ATZ

ChoosethezonewhichwillworkinArm-Disarmmode.Withthiszonesecuritysystemcanbe

activated/deactivatedwitha“low”levelimpulsewhichisnotshorterthan3seconds.Thismode

canbesetonlyforonezone.Noresistanceisconnectedwhenusing6zoneconnectiontype

andtheinputmustbeNO(normallyopen).IfATZmodeisenabledtheimpulseistransmitted

throughresistance.IfZ2-Z6zonesareused,theimpulseshouldbetransmittedthrough5.6k

resistance,ifZ7-Z12zones-theimpulseshouldbetransmittedthrough3.3kresistance.

In the environment of ESIM264 Conguration Tool the user must specify the mode

of connected Zones:

• Type1–Normallyopencontactwith5,6KΩendoflineresistor.

• Type2–Normallyclosedcontactwith5,6KΩendoflineresistor.

• Type3–Tamperand5,6KΩend oflineresistorand3,3KΩendof line resistorwith

normallyclosedcontact.

Enter code 34 and zone number:

Zone1–[3401#]

Zone2–[3402#]

Zone3–[3403#]

…

Zone12-[3412#]

Disabled–[3400#]

EKB3

Enter code 38 and Zone mode:

Type1–[381#]

Type2–[382#]

Type3–[383#]

EKB3

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Žádné komentáře

Eldes EKB3 Instalační manuál Strana 10