Eldes EKB3 Instalační manuál stáhnout pdf (Strana 132)

132

132 EN

MANUAL ELDES ESIM264 V3.1

NOTE: It is not recommend to x EWD1 in other ways than with screws, e.g. with duck tape. See Fig. No. 64 for the incorrect ways of

xing the magnetic door contact.

3. Bind the device to the alarm system by sending a corresponding command via SMS text message or using ELDES Conguration Tool

software. Please, refer to the software‘s HELP section or refer to 19.1. Binding, Removing and Replacing Wireless Devices for

more details.

4. The system automatically informs about successful/unsuccessful binding process. If attempt to bind is unsuccessful, try to move EWD1

closer to alarm system device and bind it again.

5. EWD1 magnetic door contact is ready to use.

NOTE: If you are unable to bind the wireless device please , restore the parameters of the wireless device to default and try again. See

32.4.5. Restoring Default Parameters for more details.

ATTENTION: The minimum wireless connection range between the wireless device and wireless antenna of ESIM264 system can be

0,5 meters.

32.4.3. EWD1 Zones & Tamper

Upon successful EWD1 magnetic door contact binding process,the system adds 1 wireless Instant zone and 1 wireless Panic/Silent zone.

The wireless zones are applied to the following EWD1 components respectively:

• Magnetic contact - by default, causing alarm if doors/windows is opened when system is armed.

• Panic button - by default, causing silent alarm instantly when pressed.

In case of tamper violation, the alarm is caused regardless of system being armed or disarmed. There are 2 ways to detect tamper violation

on EWD1:

• By tamper button. EWD1 has a built-in tamper button intended for monitoring the enclosure status. Once the enclosure of EWD1 is

illegally opened, the tamper button becomes unpressed. This action is followed by alarm which is sent by SMS text message and phone

call to the user (-s) by default. The SMS text message contains the violated tamper number.

• By wireless connection loss. The wireless connection loss between EWD1 and ESIM264 system leads to alarm. The system identies this event

as a tamper violation and sends alarm by SMS text message and phone call to the user (-s) by default. The SMS text message contains the violated

tamper number and a star * character indicating wireless connection loss as a tamper alarm cause.

ATTENTION: The tamper will not operate if both wireless zones are disabled.

32.4.4. Battery Replacement

1. Open EWD1 enclosure.

2. Remove the old battery from the battery slot.

3. Postition the new battery according to the appropriate batte ry slot positive terminal indicated.

4. Insert the battery into the battery slot.

5. Battery replaced.

For more details, please refer to 32.4.2. Installation.

ATTENTION: Only ER14505 Lithium Thionyl Chlorid AA type batteries can be used. Install only new, high quality and unexpired batter-

ies. Do not mix the old batteries with the new ones.

ATTENTION: At least 1 battery must be removed if the device is not in use.

ATTENTION: In order to avoid re or explosion hazards, the system must be used only with approved battery. Special care must be taken

when connecting positive and negative battery terminals. Dispose old batteries only into special collection sites. Do not charge, disassemble,

heat or incinerate old batteries.

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 167 168

Žádné komentáře

Eldes EKB3 Instalační manuál Strana 132