Eldes EKB3 Instalační manuál stáhnout pdf (Strana 139)

139

139EN

MANUAL ELDES ESIM264 V3.1

BATTERY

+ -

+- +-

+ -

BATTERY

BATTERY BATTERY

4. Close EWS2 enclosure (see Fig. No. 76, Fig. No. 75)

5. Bind the device to the alarm system by sending a corresponding command via SMS text message or using ELDES Conguration Tool soft-

ware. Please, refer to the software‘s HELP section or refer to 19.1. Binding, Removing and Replacing Wireless Devices for more

details.

6. The system automatically informs about successful/unsuccessful binding process. If attempt to bind is unsuccessful, try to move EWS2

closer to alarm system device and bind it again.

7. EWS2 siren is ready for use.

NOTE: If you are unable to bind the wireless device please , restore the parameters of the wireless device to default and try again. See

32.7.6. Restoring Default Parameters for more details.

ATTENTION: The minimum wireless connection range between the wireless device and wireless antenna of ESIM264 system can be

0,5 meters.

32.7.3. EWS2 Zone, PGM Output & Tamper

Upon successful EWS2 outdoor siren binding process,the system adds 1 wireless Instant zone and 1 wireless Siren PGM output. The wireless

zone is intended for EWS2 tamper control and the wireless PGM output is for siren control.

In case of tamper violation, the alarm is caused regardless of system being armed or disarmed. There are 2 ways to detect tamper violation

on EWS2:

• By tamper button. EWS2 has a built-in tamper button intended for monitoring the enclosure status. Once the enclosure of EWS2

is illegally opened, the tamper button becomes unpressed. This action is followed by alarm which is sent by SMS text message and

phone call to the user (-s) by default. The SMS text message contains the violated tamper number.

• By wireless connection loss. The wireless connection loss between EWS2 and ESIM264 alarm system leads to alarm. The sys tem

identies this event as a tamper violation and sends alarm by SMS text message and phone call to the user (-s) by default. The SMS

text message contains the violated tamper number and a star * character indicating wireless connection loss as a tamper alarm cause.

ATTENTION: The tamper will not operate if the wireless zone is disabled.

32.7.4. Battery Replacement

1. Open EWS2 enclosure.

2. Remove all 4 old batteries from the battery slots.

3. Postition the 4 new 1,5V alkaline AA type batteries according to the appropriate battery slot positive/negative terminals indicated on the

PCB (printed-circuit-board) of EWS2

4. Insert the batteries into the battery slots.

5. Batteries replaced.

For more details, please refer to 32.7.2 Installation.

ATTENTION: Only 1,5V Alkaline AA type batteries can be used. Install only new, high quality and unexpired batteries. Do not mix the old

batteries with the new ones.

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 167 168

Žádné komentáře

Eldes EKB3 Instalační manuál Strana 139